Can the jaw crusher discharge up to 3-5 mm?

Jaw crusher is a relatively large crushing equipment in the crushing equipment. It can be used for two kinds of materials with good mixing uniformity, and the mixing amount of materials is greatly increased. The dosage can reach 60%, which effectively reduces the cost of raw materials. But for the jaw crusher when crushing ore or rock, what is the output particle size? Can the jaw crusher discharge up to 3-5 mm? as follows:

The finished product can reach 3-5 mm

When the jaw crusher is crushing materials, the discharge opening can be adjusted according to the needs of users, so that the finished product can reach 3-5 mm. Of course, for materials with complex nature, screening or processing should be done in advance. For example, when the rock has high hardness and strong viscosity, it must be dried to adjust the hardness. In addition, the jaw crusher effectively solves the problems of high operation rate and no maintenance time caused by the low output of the original limestone crusher.
 
It can complete the crushing of large pieces of limestone. The maximum crushing particle size is 1000*1200mm, which effectively solves the original problem of "the shortage of limestone supply on the one hand and the unusable problem of storing a large amount of large limestone". The finished product is about 3 mm.
 

Jaw mill discharge opening adjustment

The jaw crusher adopts an inclined iron adjusting device: this inclined iron adjusting device is mainly used to adjust the width of the discharge opening. The inclined iron adjusting device uses bolts or worm gears or chain transmission devices to raise and lower the rear inclined iron. The front inclined iron is installed in the guide grooves of the two side walls of the frame and can only move horizontally. When the rear inclined iron is lifted, the front inclined iron moves forward along the guide groove due to the relationship of the inclined surface, the thrust plate and the movable jaw move forward with it, and the width of the discharge opening decreases accordingly. Conversely, when the rear inclined iron drops, the width of the discharge opening increases. This kind of adjustment device realizes stepless adjustment, and there is no need to stop during adjustment.

The method of jaw crusher discharging irregularities

In work, when the jaw crusher is not discharged smoothly, the problem can be solved by adjusting the size of the coarse crusher's discharge port. The method of adjusting the size of the discharging port of the coarse crusher: 1 adopts a hydraulic safety device, which is safe and easy to troubleshoot; 2 the bearing parts that require forced lubrication are wear-resistant and bear a large impact load; 2 increase or decrease the gasket layer To increase or decrease the discharge port of the jaw crusher.